Skip to content
Licensed & Fully Insured
SC Concrete
Services

Stamped Concrete in Westland, MI

Stamped Concrete

Decorative patterns and textures that mimic stone, brick and slate.

Stamped concrete gives you the look of stone, slate, brick or wood plank in one continuous slab, with no pavers to shift and no weeds growing between them. We color it, stamp it and seal it so the pattern stays sharp and the color stays rich.

Typical price$18–$28 / sq ftinstalled in Metro Detroit · cost guide →
Ashlar slate stamped concrete patio with a red brick-pattern border
What we build

Stamped Concrete, start to finish

  • Stamped patios
  • Stamped driveways and borders
  • Ashlar slate, cobblestone, brick and wood-plank patterns
  • Integral and release colors
  • Sealed for color and slip resistance
Key considerations

What goes into it

  1. 01Pattern and color picked with you
  2. 02Timing the stamp to the set
  3. 03Release color for depth
  4. 04Sealer that suits Michigan winters
  5. 05Resealing schedule to keep it sharp

Because Michigan weather is hard on concrete, we put the most care into the parts you can’t see: proper sub-base, reinforcement, and curing that make your concrete last.

What’s under the surface

A Michigan driveway, in cross-section

Not to scale · slope exaggerated
1Wet clay freezes and heaves in winter, then softens and settles in spring, moving whatever sits on top of it.
2Soft clay comes out and compacted 21AA aggregate goes in, so the slab sits on something that stays put.
3Rebar on chairs at mid-depth keeps any cracks that do form tight and level.
4An air-entrained mix survives freeze-thaw, and control joints decide where the slab cracks.
5The slab slopes away from the house, with an isolation joint where it meets the foundation.
How it runs

Estimate to final walkthrough

  1. 1Free estimate with pattern and color samples
  2. 2Clear quote for the design you pick
  3. 3Prep, pour, color and stamp
  4. 4Cure, seal and final walkthrough
Finish options

Straightforward or decorative

Broom finish
Fine ridges for traction on snow and ice. The standard for driveways.
Stamped
Patterned and colored to look like stone, slate or brick.
Exposed aggregate
The surface washed back to show the stone. Grippy and hides wear well.
Integral color
Color mixed through the whole slab, so chips don’t show grey.
Decorative borders
A contrasting band that frames a driveway or patio.
Sealed
Sealer before the first winter to resist water and road salt.
Where you live changes the job

A stamped concrete project on lake-plain clay is a different job than one on sandy outwash

Metro Detroit sits on three kinds of ground, and each one changes how we prepare the base, reinforce the slab and handle water. Your community page has the specifics.

Lake-plain clay

Dig out the soft clay, replace it with compacted 21AA aggregate base, and set the slope so water runs off the slab and away from the house.

Rolling glacial till

Proof-roll the subgrade to find soft spots, replace them, build a thicker compacted base, and plan the grade so runoff is carried around the slab.

Sandy outwash

Compaction done in lifts, a full-depth aggregate base, and a thicker section anywhere a truck, trailer or RV will park.

Questions and answers

Stamped Concrete: what people ask us

Stamped and colored concrete typically runs $18–$28 per square foot installed in Southeast Michigan, so a 300 square foot patio is around $5,400–$8,400. One pattern and color sits toward the low end; multi-color patterns, borders and hand detailing toward the top. A stamped border around a broom-finished slab, about $3–$6 per linear foot of edge, gets much of the look for less.

Typical prices for every kind of project are in the Metro Detroit concrete cost guide, and general questions are on the FAQ page.

Get a clear price on your stamped concrete project.

Get a free, no-pressure estimate from a local team that treats your home like its own.